BIXOLON SRP-270 ①SHAFT Pulley, ②LEVER Tension, Belt, ③PULLEY, ④WASHER, ①SUB PCB, ②SWITCH Lever

8-8-1-4 Lever Tension Belt C Assy

Name of Parts		Method and Procedure
①SHAFT PULLEY	1.	At first, grease ①SHAFT PULLEY
②LEVER TENSION		with HG-31S.
BELT	2.	Next insert ③PULLEY and then
③PULLEY		assemble ④WASHER (2.6*5.0*0.5).
④WASHER	<Check Point>
(2.6*5.0*0.5)	Check ③PULLEY to rotate smoothly.

8-8-1-5 Sub PCB Assy

Name of Parts	Method and Procedure
①SUB PCB	1. Insert ②SWITCH LEVER to fit the
②SWITCH LEVER	hole of ①SUB PCB.
③WIRE ASSY	2. And then, solder the land on the
	①SUB PCB bottom side and attach
	the ③WIRE ASSY on the land A, G.
	<Check Point>
	After soldering, check the frozen lead
	and short.
8-8-1-6 Cover Head Assy
Name of Parts	Method and Procedure
①COVER HEAD	1. Insert the ②SCREW MANUAL into
②SCREW MANUAL	the right side hole of ①COVER
③E-RING (ø2.5)	HEAD.
④CAUTION LABEL	2. And then, assemble ③E-RING onto
	the starting point of a spiral during
	adhering closely to the ①COVER
	HEAD.
	3. Paste the ④CAUTION LABEL on
	the right bottom side.

SRP-270

Drawings

Drawings

Drawings

Rev. 3.02 - 76 -