
2-1-5 Paper Roll Installation
1.Using a new roll paper, unroll the paper and cut the end as shown.
2.In case of Model 270C/D, open Auto Cutter on the power ON.
3.Auto feeding one paper.
4.Put first paper into Auto Cutter, set second paper rolling Spool Winding to Lower Case.
5.Setting Auto Cutter, then put first paper to the middle of guide for cover Printer and pull it out close cover.
SRP-270
6.If the paper is loose, wind the Rewind Spindle to tighten the paper.
7.Release the holder after fitting the Roll Paper Core onto the Holder. Make sure to load the paper roll so that it rotates in the correct direction.
Rev. 3.02 | - 10 - |