Tools, Lubricants and Adhesives, Repair | BIXOLON SRP-270 specification

SRP-270

8-5 Tools, Lubricants and Adhesives

8-5-1 List of Tools

No	Tool Designation		Availability
1	Brush #1		O
2	Brush #2		O
3	Cleaning brush		O
4	Screwdriver (+) No.2		O
5	Tweezers		O
6	Round pliers		O
7	Diagonal cutting nipper		O
8	Electric Soldering iron		O
9	Thickness gauge		O
10	ET holder #2.5		O
11	ET holder #3		O
8-5-2 List of Lubricants and Adhesives

Item	Oil	Grease	Adhesive
Description	CALTEX REGAL R/D #68, 948P	HG-31S	Screw lock

8-6 Repair

In Consideration of the level of expertise required for implementation of after-service and repair procedures for this printer, such procedures have been grouped into two rankings: Level A and Level B.

The person in charge of repair, therefore, should perform the repair procedures appropriate to the class and to his/her own level of expertise.

8-6-1 Repair Levels

1)Level A: Requires general knowledge and technical skills regarding the operating principles and construction of the printer, but does not require previous repair experience.

2)Level B: Requires full knowledge and technical skills regarding the operating principles and construction of the printer as well as previous repair experience.

8-6-2 Repair Procedures

In the case a problem occurs, check its symptoms and status .clarify the source of the problem with reference to subsection 8-6-3 Repair guidelines, then repair the damaged area Note that the tables of subsection 8-6-3 Repair Guidelines, consist of the 5 items listed below, enabling troubleshooting and repair to be performed with speed and efficiency with minimum error.

1)Phenomenon: Check the symptoms of the trouble.

2)Condition: Compare the trouble status of problem with the description of this column and locate the matching status.

3)Cause: This column lists the potential causes on the basis of the trouble status, allowing the location of the trouble to be checked. It also lists the repair level for each cause, so be sure to refer to this column before attempting repair.

4)Check point and Method: In correspondence to the cause, this column lists what parts to check as well as the checking procedure to be used. Be sure to inspect the check-points according to the method described here.

5)Repair Method: Repair the trouble area according to the description in this column. If the identical phenomenon and condition remain unchanged after performing the repair, check another item of the "CAUSE" column then perform the pertinent repair.

Rev. 3.02

- 67 -