BIXOLON SRP-270 ①SUB PCB Assy, ②SCREW Tapping M2*3, 2EA, ③MANUAL Cutter, ⑤PLATEN Paper Guide

			SRP-270
8-8-2-3 Base Paper Feed Assy - #3
Name of Parts		Method and Procedure
①SUB PCB ASSY	1. Set ①SUB PCB ASSY to fit the hole in the bottom face of
②SCREW TAPPING (M2*3, 2EA)	BASE PAPER FEED and tighten two ②SCREW TAPPING.
③MANUAL CUTTER	2. Set the ③MANUAL CUTTER to the boss on the BASE
④SCREW (M3*6, 2EA)	PAPER FEED and tighten two ④SCREW.
⑤PLATEN PAPER GUIDE	3. Hook ⑤PLATEN PAPER GUIDE on the manual cutter in the
⑥SHAFT HOLE ROLLER	front face of BASE PAPER FEED.
⑦HOLE ROLLER (2EA)	4. Grease section of ⑥SHAFT HOLE ROLLER mounted HOLE
⑧SPRING HOLD ROLLER (2EA)	ROLLER and insert two ⑦HOLE ROLLER. Next, set SHAFT
	to the each groove of BASE PAPER FEED as fitting HOLD
	ROLLER into PPG.
	5. Hook two ⑧SPRING HOLD ROLLER on the both side of
	BASE PAPER FEED.
	<Check Point>
	Check the location of PLATEN PAPER GUIDE, status of
	hooking, coming off.

Rev. 3.02 - 80 -