BIXOLON SRP-270 service manual Sub-assemblies, Check Point

8-8-1 Sub-assemblies

8-8-1-1 Carriage Head Assy

Name of Parts	Method and Procedure
①BERIN G FE (2ea)	1. At first, set the ①BERIN G FE
②CARRIAGE HEAD	to be inserted into the shaft of JIG.
	* Notice: The direction of insert
	is to locate frange downward.
	2. And then, set a ②CARRIAGE HEAD
	to be inserted into the shaft of JIG.
	3. Next , set other ①BERIN G FE to be
	inserted into the shaft of JIG.
	* Notice: The direction of insert is to
	locate frange upward.
	4. Lastly, insert two ①BERIN G FE in
	the ②CARRIAGE HEAD by pushing
	the handler of Lever Press.
	< Check Point>
	Check improper insertion of ①BERIN
	G FE and fraction of ②CARRIAGE
	HEAD.

8-8-1-2 Lever Ribbon Feed Assy

Name of Parts	Method and Procedure
①SHAFT REDUCTION	1. At first, Grease ①SHAFT on the ②
“B”	LEVER RIBBON FEED with HG-
②LEVER RIBON FEED	31S.
③GEAR REDUCTION	2. And then, Assemble ④WAVE
“B”	WASHER and Grease ④WAVE
④WAVE WASHER	WASHER.
⑤E-RING (ø2.5)	3. Last, assemble ③GEAR
	REDUCTION “B” and ⑤E-RING
	(ø2.5).

SRP-270

Drawings

Drawings

8-8-1-3 Ribbon Feeder Assy

Name of Parts	Method and Procedure
①SPRING RIBBON	1. Grease ①SPRING RIBBON
FEEDER	FEEDER with HG-31S and insert
②RIBBON FEEDER	that into ②RIBBON FEEDER.
③GEAR RIBBON	2. And then, insert ③GEAR RIBBON
FEEDER	FEEDER to fit the section of hook.

Drawings

Rev. 3.02 - 75 -