SRP-270
2. Installation and Operation
|
|
1.Mack sure the printer is turned off with the “Off” side of the switch is pressed down.
2.Check the label on the AC Adapter to make sure the voltage required by the AC Adapter matches that of the electrical outlet.
3.Plug the DC cord connector into the power jack on the printer.
4.Plug the AC Adapter power cord into the wall outlet.
|
1.Turn off the printer, host ECR and Computer.
2.Plug
3.Tighten the screws on both sides of the connector.
4.Turn on the printer, host ECR and Computer.
Cash Drawer Connector
Cash Drawer Cable
1.Turn the printer off.
2.Plug the Cash Drawer cable connector into the connector on the printer. (To remove the Cash Drawer cable, press the clip on the connector, grasp the connector and pull it out.)
3.Secure the Shield Wire on the bottom of the printer.\
1.Before inserting the ribbon cartridge, turn the Knob.
2.Insert the ribbon cartridge. Pay particular attention to the placement of the ribbon behind the Print Head.
3.After inserting the ribbon cartridge, turn the knob clockwise again to make sure the ribbon moves freely in the cartridge.
Rev. 3.02 | - 9 - |