Toshiba PROSEC T3H user manual Maintenance

Page 6

Safety Precautions

Maintenance:

!CAUTION

1.Do not charge, disassemble, dispose in a fire nor short-circuit the batteries. It can cause explosion or fire. Observe local regulations for disposal of them.

2.Turn off power before removing or replacing units, terminal blocks or wires. Failure to do so can cause electrical shock or damage to the T3H and related equipment.

3.Replace a blown fuse with a specified one. Failure to do so can cause fire or damage to the T3H.

4.Perform daily checks, periodical checks and cleaning to maintain the system in normal condition and to prevent unnecessary troubles.

5.Check by referring “Troubleshooting” section of the T3 User’s Manual - Hardware, when operating improperly. Contact Toshiba for repairing if the T3H or related equipment is failed. Toshiba will not guarantee proper operation nor safety for unauthorized repairing.

6.The contact reliability of the relays used in the relay output module will reduce if the switching exceeds the specified life. Replace the module if exceeded.

7.Replace the battery every 2 years to maintain the T3H’s program and data normally.

8.Do not modify the T3H and related equipment in hardware nor software. This can cause fire, electrical shock or injury.

9.Pay special attention for safety if you attempt to measure circuit voltage at the T3H’s terminal.

10.Turn off power before replacing modules. Failure to do so can cause electrical shock or damage to the T3H and related equipment.

If you attempt to replace an I/O module while power on (by using on-line I/O replacement function), carefully check for safety.

4 PROSEC T3H

Image 6
Contents USER’S Manual Important Information General Information Hazard ClassificationsSafety Precautions Installation WiringOperation Maintenance Safety Label T3 manuals About This ManualTerminology VacContents Prosec T3H Section T3H Overview Introducing the T3H Differences between T3H and T3 T3H components CPU module Two types of T3H CPU modules are availableRAM/ROM switch Mode control switchStatus LEDs Computer link port Battery coverProgrammer port IC memory card slotExpansion interface module T3H CPU CH1 CH2CPU Power supply module RackExpansion cable O module Following types of I/O modules are availableTOSLINE-S20LP Data transmission moduleModule internal current consumption AsciiSpecifications Functional specifications SFCRAS Instruction execution speed Test TeorTenr DtstTset SETRST TrstCOS PID2SIN TANInstruction execution speed cont’d Shown below Section Expanded Functions Timer interrupt interval System operation Auto-RUN / Standby selectionSaving the sampling trace condition Expanded registers External I/O registerAuxiliary register Timer Link registerLink Global File register Special registerExpanded Functions SEND/RECVTOSLINE-S20 Expanded Functions Expanded file register data read MR Starting registerExpanded file register data Write MW ADR S TExpanded Functions TOSLINE-S20LP loop support Ethernet support Instructions Double-word multiplication and division D∗ Expanded Functions Essential PID PID3 DSVControl block diagram AlgorithmParameter details Operation ASV ← ISVExpanded Functions Floating point essential PID FPID3 Digital filter PVn = 1− FT⋅ PVC+ FT⋅ PVn − Here ≤ FT ASV differential limit DSV 0 to 100 %/∆ t Data range +1 ⋅C Expanded Functions Expanded data transfer Xfer Transfer parameter table TypeCPU register ↔ Expanded F register IC memory card CPU register ↔ S20/S20LP scan memory CPU register ↔ Eeprom D register When the data writing address range exceeds page boundary Network data send Send MIDExpanded Functions S20LP T3H self-station RW100 RW101 RW227 Network data receive Recv Expanded Functions H0A Expanded Functions Prosec T3H Toshiba Corporation