Toshiba B-850 owner manual SENSOR1 0 0 0 0 0 0 0 0 1 0 0 1

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.7 Additional Information

A4.7.1 Self-Diagnostic Test Result Sample and Descriptions (Cont.)

(8)Sensor 1 Check

The status of the Cutter Home Position Sensor, Ribbon Feed Motor Sensor, and Ribbon Rewind Motor Sensor are printed.

	SENSOR1 0 0 0 0 0 0 0 0 , 0			1 1 1 0 0 1 1
											Fixed to 1.
		Fixed to 0.
										Fixed to 1.
			Fixed to 0.						Cutter home position switch status
Ribbon feed motor sensor 2 status										0: Home position
										1: Other position
	0: The detecting point is positioned
								Fixed		to 0.
	outside the slit.
	1: The detection point is positioned						Ribbon rewind motor sensor 1 status
	inside the slit.						0: The detecting point is positioned outside the slit.
							1: The detecting point is positioned inside the slit.
						Ribbon feed motor sensor 1status
							0: The detecting point is positioned outside the slit.
							1: The detecting point is positioned inside the slit.
			Sensor/Switch							Print status content description
	Cutter home position switch				Indicates whether or not the cutter is at the home
					position.
	Ribbon rewind motor sensor 1				Controls ribbon motor rotation by detecting the slit on
	Ribbon feed motor sensors 1 and 2				the ribbon rewind motor and the ribbon feed motor.
					Indicates the position of the slit sensor.

(9)Sensor 2 Check

The status of the Print Head Thermistor, Environmental Temperature Thermistor, Heat Sink Thermistor, Black Mark Sensor (Upper/Lower), and Feed Gap Sensor are printed.

SENSOR2 [H]20°C [A]22°C [S]25°C [R(U)]3.3V [R(L)]4.0V [T]2.4V

Feed gap sensor status: 0.0 – 5.0V

Black mark sensor (Lower) status: 0.0 – 5.0V

Black mark sensor (Upper) status: 0.0 – 5.0V

Heat sink thermistor status: 25°C, 80°C, 90°C

Environmental thermistor status: 0 - 86°C

If it is undetectable, “-- °C “ is printed.

Print head thermistor status: 0°C - 86°C

A4-25