Toshiba B-850 owner manual At the same time

2. PRINTER SETUP

EO1-33029

2.11 Test Print

2.11 Test Print (cont.)

NOTE:

If an error occurs during the print test the printer will display an error message and stop printing. Refer to Chapter

6.1for a definition of error messages.

The error may be cleared by pressing the [PAUSE] key but the test print will not be resumed and the LCD message display will return to showing:

<1> DIAG. V1.0A

NOTE:

When the [PAUSE] key is pressed in Step 10, the printer will enter each print pattern detailed on the setting menu mode. To exit, press the

[FEED] and [RESTART] keys

at the same time.

8.Press the [PAUSE] key again and the printer will now print five labels of sample bar codes lines and the LCD Message Display will continue to display the following message.

$872￿35,17￿￿5()/￿￿

9.Press the [PAUSE] key again and the printer will now print five labels of characters of various sizes and the LCD Message Display will return to showing the test print start message as shown below.

￿￿!7(67￿35,17￿

10.Upon pressing the [RESTART] key for the second time in step 6, the LCD Message Display will change to that shown below.

$872￿35,17￿￿75$1￿￿

11.Press the [PAUSE] key and the printer will issue one blank label and will then print five labels of slant lines and the LCD Message Display will continue to display the following message.

$872￿35,17￿￿75$1￿￿

12.Press the [PAUSE] key again and the printer will now print five labels of sample bar codes lines and the LCD Message Display will continue to display the following message.

$872￿35,17￿￿75$1￿￿

13.Press the [PAUSE] key again and the printer will now print five labels of characters of various sizes and the LCD Message Display will return to showing the test print start message as shown below.

￿￿!7(67￿35,17￿

14.If necessary, the print test may now be repeated from step 4.

15.When you have finished performing the test print operation, turn the printer’s power OFF then back to ON and check that the LCD Message Display shows ON LINE and that the ON LINE and POWER LED lights are illuminated.

2-16