Toshiba B-850 owner manual Installing the Media and reassembling the Supply Holder Unit

2. PRINTER SETUP

EO1-33029

2.7 Loading the Media

2.7.1Installing the Media onto the Supply Holder Unit (cont.)

WARNING!

If you turn the Removable Supply Holder side down after loading the media, the media may drop by weight. You might be injured by the dropped media.

CAUTION!

When installing the media roll, do not push on the Non-removable Supply Holder as this will result in the media roll not being properly centred.

The diagram below, and the steps that follow, show the procedures for installing the Media onto the Supply Shaft and reassembling the Supply Holder Unit. Be sure to follow the step-by-step procedure exactly or the auto centering mechanism may not work properly.

Removable

Supply Holder Print Side

4

Green Supply

Holder

Locking Knob 31

2

Slot	Supply Shaft	Non-removable
Tab		Supply Holder
		Media Roll

NOTES:

1.This supply holder accepts four sizes of media core: 38 mm, 40 mm, 42 mm and 76.2 mm.. When using a media roll of 38 mm, 40 mm, or 42 mm, remove the spacers from the supply holders by pushing both hooks of the spacer. Keep the removed spacers safe.

2

Spacer

Installing the Media and reassembling the Supply Holder Unit

1.	Place the media roll onto the Supply Shaft with the media feeding
	from the bottom as shown in the diagram above. c
2.	Align the tab of the Removable Supply Holder with the Slot in the
	Supply Shaft, then reinstall the Removable Supply Holder by sliding it
	onto the Supply Shaft as shown in the figure above.
3.	Holding the reassembled Supply Holder Unit in your right hand, apply
	pressure only to the reinstalled Removable Supply Holder to push it in
	the direction of arrow d, causing the auto centering mechanism to
	center the media on the Supply Shaft.
4.	Tighten the green Supply Holder Locking Knob for the Removable
	Supply Holder by turning it in the direction of arrow e.
5.	Tighten the green Supply Holder Locking Knob for the Non-

1

Supply

1

Holder

2.Use only inside wound label stock. Outside wound label stock may not feed properly.

Use outside wound label stock at your own risk.

3.Do not over-tighten the green supply holder locking knob.

2- 8