Toshiba B-850 owner manual Operating Modes

3. PRINTER OPERATION EO1-33029

3.2 Operating Modes

3.2Operating Modes (Cont.)

CAUTION!

∙Be sure to cut the backing paper of label. Cutting labels will cause the glue to stick to the cutter, which may affect the cutter quality and shorten the cutter life.

∙Use of tag paper when the thickness exceeds the specified value may affect the cutter life.

NOTE:

Cut mode is available only when the optional cutter module (B-7208-QM) is installed.

2.Continuous (or batch) mode – In this mode, the labels will be continuously printed and fed until the number of labels specified in the label issue command has been printed. After the last label of the series has been printed the labels can be torn free from the supply roll in a similar manner as described in the tear off mode above.

3.Cut Mode - In the cut mode, as each label is printed it is fed forward to the cutter mechanism where the swing cutter mechanism will precisely cut the label off from the supply roll. The feed mechanism will then backfeed the label or card stock until it is properly positioned under the print head to print the next label in series. The issue command sent to the printer from the Host can inform the printer to cut each label or tag after each has been printed or to perform the cut only after a certain number of labels or tags have been printed and issued.

3- 2