Toshiba B-850 owner manual Inserting the Optional Pcmcia Cards, Com

2. PRINTER SETUP

EO1-33029

2.10 Inserting the Optional PCMCIA Cards

2.10Inserting the Optional PCMCIA Cards

CAUTION!

1.To protect PC cards, discharge static electricity from your body by touching the metal cabinet of the printer before touching the card.

2.Before inserting or removing a PCMCIA card make sure that the printer’s power is turned off.

3.Be sure to protect PCMCIA Cards when not in use by putting them into their protective covers.

4.Do not subject the card to any shocks or excessive force nor expose the card to extremes in temperature or humidity

5.The card may be inserted into the slot halfway even in the wrong orientation. However, the slot is safety designed so that the card will not seat against the connector pins.

When the optional PCMCIA interface board is installed into the B-852 printer, there will be two PCMCIA slots available as shown in the figure below. This allows for the use of Flash Memory Type Cards or I/O type Cards such as LAN Cards. The following paragraphs outline how to insert PCMCIA cards.

1.Make sure that the printer’s power switch is in the OFF position.

2.Hold the PCMCIA Card so that the model name printed side faces right. Insert the card into the proper slot until the Eject Button pops out.

Slot 0:

(Memory type cards only)

Slot 1:

(I/O type cards such as LAN cards)

Eject Button

Model Name Printed Side

3.The following PCMCIA cards can be used.

Type	Maker	Description		Remarks
ATA Card	San Disk	A card conforming to		----------
	Hitachi	the PC card ATA
		standard
		Ether Link III 3C589D		Install into the slot
		PC card
				(1) only. (This card
LAN Card	3 COM	Megahertz®
				installed into the slot
		10M bps LAN PC Card
				(0) will not work.)
		3CCE589ET Series
Flash
		EF-4M-TB	CC
Memory	Maxell			----------
Card (4 MB)		EF-4M-TB	DC

2-14