Toshiba B-850 owner manual A4.6 PCL Emulation Setting, Auto Print

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.6 PCL Emulation Setting

A4.5 Test Print (Cont.)

NOTE:

Select “AUTO PRINT (TRAN)” when using labels, and “AUTO PRINT (REFL)” when using tag paper.

A4.6 PCL Emulation Setting

Outline of the PCL Emulation

The PCL Emulation is the function to emulate Hewlett Packard laser printers. When your laser printer is a Hewlett Packard, you can use the B- 852 printer in place of the laser printer without changing the printer driver by selecting “EMULATION ON”. In this case, the Print speed, Sensor type, Printing mode, Issue mode, and Media size should be specified.

NOTE:

This function is available only when the optional PCL Emulation Board (B-7708- PCL-QM) is installed. When you need the PCL Emulation Board, please contact your nearest TOSHIBA TEC service representative.

Auto Print

$872￿35,17￿75$1￿￿	Feed Gap Sensor
$872￿35,17￿5()/￿￿	Black Mark Sensor

While selecting the Auto Print, press the [PAUSE] key to feed one media and print slant lines (3 dots) on 5 pieces of media.

Next, press the [PAUSE] key to print bar codes on 5 pieces of media. Pressing the [PAUSE] key again causes the printer to print characters on 5 pieces of media.

The PCL Emulation Setting menu contains the following:

￿￿!3&/￿(08/$7,21￿

[PAUSE]

(08/$7,21￿2))￿ Emulation ON/OFF Selection

[PAUSE]

35,17￿63(('￿￿´￿V￿	Print Speed Selection
[PAUSE]
6(1625￿75$16￿￿	Sensor Type Selection
[PAUSE]
357￿7<3(￿75$16)5￿	Printing Mode Selection
[PAUSE]
7<3(>6@12￿&87￿	Issue Mode Selection
[PAUSE]
0(',$￿￿￿$￿￿	Media Size Selection
[PAUSE]

While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Hold both keys until the “<1>DIAG. Vx.x” Message appears.

￿￿!',$*￿￿￿￿9[￿[￿

Press the [FEED] key 3 times.

The printer is at the start of the PCL Emulation menu.

￿￿!3&/￿(08/$7,21￿

When “<8>PCL EMULATION” appears, press the [PAUSE] key.

A4-19