APPENDIX 4 SYSTEM MODE
A4.3
A4.3 Self-Diagnostic Test
Outline of
In the
The
!',$*9[[
[PAUSE]
3577<3(75$16)5 Selection of the printing mode.
[PAUSE]
performs the print head broken element check.
NOTE:
Use the [FEED] or [RESTART] key to select a desired option.
0$,17(1$1&(&217
[FEED] [RESTART]
$872',$*1267,&
[FEED] [RESTART]
+($'&+(&.
[FEED] [RESTART]
Prints out the Maintenance Counter /Parameter Settings.
Performs a
Checks to see if there is any problem with the print head.
NOTE:
“x.x” of “DIAG. Vx.x”
indicates firmware version and
i i
NOTE:
When using the ribbon, be sure to select “Thermal Transfer”. When using thermal media, be sure to select “Thermal Direct”.
NOTE:
See Section A4.7.1 for the Maintenance Counter/Parameter Settings print sample and detailed descriptions for each.
While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Hold both keys until the “<1>DIAG.” Message appears in the display.
!',$*9[[
Printing mode selection
Press the [PAUSE] key. The type of printing mode can be selected: “TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).
After selecting the printing mode to be used, press the [PAUSE] key.
[RESTART] | 3577<3(75$16)5 | Thermal transfer |
|
| |
[FEED] | 3577<3(',5(&7 | Thermal direct |
|
|
Maintenance counter/parameter settings print out
The printer is ready to print out the Maintenance Counter/Parameter Settings. Press the [PAUSE] key to start.
0$,17(1$1&( &217
The printer starts printing out the Maintenance Counter/Parameter Settings.
&+(&.,1*35,17
After printing is completed, the display returns to “<1>DIAG. Vx.x”.
A4- 3