Toshiba B-850 owner manual A1.3.2 Detection Area of the Transmissive Sensor

APPENDIX 1 SPECIFICATIONS EO1-33029

A1.3 Media

A1.3.1 Media Type (Cont.)

				[Unit: mm]
	Label dispensing mode	Batch mode		Cut mode
Item
cMinimum media pitch		15.0		Label: 38.0
				Tag: 25.4
d
eLabel length		Min. 12.5		Min. 32.0
fWidth including backing paper		100.0- 242.0		100.0 – 235.0
gGap length		2.5 – 20.0		6.0 – 20.0
hBlack mark length (Tag paper)			2.0 – 10.0
iEffective print width			216.8±0.2
jPrint speed up/slow down area			1.0
Black mark length (Label)		2.0 – 20.0		6.0 – 20.0
Max. print length			640.0
Maximum effective length for on the fly issue			320.0
Max. outer roll diameter			φ230
Thickness	Label + backing paper		0.13 – 0.18
	Tag		0.08 – 0.18

NOTES:

1.To ensure print quality and print head life use only TOSHIBA TEC specified media.

2.When using the cutter ensure that label length dplus inter-label gap length fexceeds 38 mm. (i.e. label pitch should be greater than 38 mm.)

3.When requesting black marks on label rolls, the following requirements must be satisfied. When the gap length is less than 4 mm:

The black mark length should be longer than the gap length. When the gap length is 4 mm or more:

The black mark should not overlap the gap for more than 4 mm or the following label.

Black marks should be printed on reverse side of the gaps. Also, they should contact or overlap the preceding label’s bottom end line.

4.“On the fly issue” means that the printer can feed and print without stopping between labels.

A1.3.2 Detection Area of the Transmissive Sensor

The transmissive sensor is movable from the center to the left edge of media.

The transmissive sensor detects a gap between labels, as illustrated below.

		Area to be detected.			Center of media
Sensor position					Print side
Min. 2.0 mm			Label
			Gap
(Min. 6.0 mm when using
the cutter module.)			Label
	Min. 12 mm				Media feed direction
				Sensor is movable
				within this range.

A1- 3