Appendix 1 Messages and Leds | Toshiba B-SX4T specification

APPENDIX 1 MESSAGES AND LEDS

ENGLISH VERSION EO1-33058

APPENDIX 1 MESSAGES AND LEDS

Appendix 1 describes the LCD messages displayed on the operation panel.

Symbols in the message

1:: The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.

2:****: the number of unprinted media. Up to 9999 (in pieces)

3:%%%%%%%: ATA Card’s remaining memory 0 to 9999999 (in K bytes)

4:###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)

5:&&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)

		LED Indication		Restoration by	Acceptance of
No.	LCD Message		Printer Status	RESTART key	Status Request

		POWER ONLINE ERROR		Yes/No	Reset Command
					Yes/No

1	ON LINE			z	In online mode	-----	Yes
1	ON LINE		~	z	In online mode (The printer in	-----	Yes
	ON LINE		~	z	communication)
2	HEAD OPEN		z	z	The print head block is opened in online	-----	Yes
2	HEAD OPEN		z	z	mode.
3	PAUSE ****		z	z	The printer is paused.	Yes	Yes
					A parity, overrun, or framing error has	Yes	Yes
4	COMMS ERROR		z		occurred during communication through
					the RS-232C.
5	PAPER JAM	****	z		The media is jammed during paper feed.	Yes	Yes
6	CUTTER ERROR****		z		A problem has occurred with the cutter	Yes	Yes
6	CUTTER ERROR****		z		module.
7	NO PAPER	****	z		The media has run out, or the media is	Yes	Yes
7	NO PAPER	****	z		not loaded properly.
8	NO RIBBON	****	z		The ribbon has run out.	Yes	Yes
9	HEAD OPEN	****	z		Feed or printing was attempted with the	Yes	Yes
9	HEAD OPEN	****	z		print head block open.
10	HEAD ERROR		z		There is a problem with the print head.	Yes	Yes
11	EXCESS HEAD TEMP		z		The print head is overheated.	No	Yes
					The ribbon has been torn. A problem	Yes	Yes
12	RIBBON ERROR****		z		has occurred with the sensor that
12	RIBBON ERROR****		z		determines the torque for the ribbon
					motor.
13	REWIND FULL ****		z		An overflow error has occurred in the	Yes	Yes
13	REWIND FULL ****		z		rewinder unit.
	SAVING%%%%%%%				In writable character or PC command	-----	Yes
14	or			z	save mode
	SAVING ###&&&&
15	FLASH WRITE ERR.		z		An error has occurred while writing to	No	Yes
15	FLASH WRITE ERR.		z		flash memory or ATA card.
					An erase error has occurred in	No	Yes
16	FORMAT ERROR		z		formatting the flash memory or ATA
					card.
17	FLASH CARD FULL		z		Data cannot be stored because the flash	No	Yes
17	FLASH CARD FULL		z		memory or ATA card is full.
18	Display of error		z		A command error has occurred in	Yes	Yes
	message (See Notes.)				analyzing the command.
19	POWER FAILURE		z		A power failure has occurred.	No	No
20	INTIALIZING…		z	z	A flash memory card is being initialised.	-----	-----
21	EEPROM ERROR		z		Data cannot be read from/written to a	-----	-----
					backup EEPROM properly.

EA1- 1