Toshiba B-SX4T owner manual Head Up Cut/Rewinder Selection, Feed key

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.9 Setting an Operating Environment

2.9.1Parameter Setting (Cont.)

When ON is selected, pressing the [PAUSE] key will result that the LCD Message Display shows the stop position fine adjustment value setting screen.

<2>PARAMETER SET POSITION +0.0mm

	POSITION +5.0mm
[RESTART]
	POSITION +0.0mm
[FEED]
	POSITION -5.0mm
[FEED] key:	Pressing the [FEED] key one time causes a –0.5mm change,

up to –5.0 mm.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.5mm change, up to +5.0 mm.

NOTE:

The print head may not be raised depending on the rise of the solenoid’s temperature.

After selecting an auto forward wait, press the [PAUSE] key.

(10) Head Up Cut/Rewinder Selection

This parameter is to choose whether to activate the head up action in the cut issue or to use the Rewinder in the batch or strip issue.

This function prevents ribbon smudges by raising the print head during a reverse feed to the print start position.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET HU CUT/RWD OFF

Use the [FEED] or [RESTART] key to select a desired option.

		HU CUT/RWD	ON
[RESTART]
		Head up cut is activated or the Rewinder
		is used.
	[FEED]
		HU CUT/RWD	OFF

Head up cut is not activated or the Rewinder is not used.

After selecting the head up action in cut issue or use of the Rewinder, press the [PAUSE] key.

E2-20