Toshiba B-SX4T owner manual Do not over-tighten the Locking Ring of the Supply Holder

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.4 Loading the Media

2.4Loading the Media (Cont.)

NOTE:

Do not over-tighten the Locking Ring of the Supply Holder.

5.Put the media on the Supply Shaft.

6.Pass the media around the Damper, then pull the media towards the front of the printer.

7.Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the Supply Holder against the media until the media is held firmly in place. This will centre the media automatically.

Then turn the Locking Ring clockwise to secure the Supply Holder.

Groove Damper

Supply Holder

Projection

	Media	Supply Shaft		Locking Ring
In case of a label rolled with			In case of a label rolled with
the print side facing inside.			the print side facing outside.

MediaDamper

8.Place the media between the Media Guides, adjust the Media Guides to the media width, and tighten the Locking Screw.

9.Check that the media path through the printer is straight. The media should be centred under the Print Head.

Media Guide Print Head Supply Holder

Locking Screw Media Media Guide

E2- 5