Toshiba B-SX4T owner manual Detection Area of the Reflective Sensor, Effective Print Area

7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33058

7.1 Media

7.1.3 Detection Area of the Reflective Sensor

The Reflective Sensor is movable from the centre to the left edge of media.

The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.

Sensor should be positioned at the centre of the black mark.

Min. 2.0 mm

Min. 12 mm

Sensor is movable within this range.

Centre of media

Detecting the black marks on the back.

Media feed direction

7.1.4 Effective Print Area

The figure below illustrates the relation between the head effective print width and media width.

Out of print range				Out of print range
		104 mm±0.2
	4 mm	(Head Effective Print Range)	4 mm

112 mm (Max. media width)

The figure below shows the effective print area on the media.

Area to be detected.

Start line

1.5mm from the left edge of media

1mm
	Media height
	10 – 1500 mm
Guaranteed print area	1.5 mm from the
	right edge of media
1mm	Media feed direction

Area to be detected.

Media width

(backing paper width is not included.)

NOTES:

1.Be sure not to print on the 1.5-mm wide area from the media edges (shaded area in the above figure). Printing this area may cause ribbon wrinkles, resulting in a poor print quality of the guaranteed print area.

2.The centre of media is positioned at the centre of the Print Head.

3.Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print speed slow down) is not guaranteed.

E7- 3