REMOTE CONTROL FEATURES
In addition to controlling this unit, the remote control can also operate other A/V components made by YAMAHA and other manufacturers. To control other components, you must set up the remote control with the appropriate remote control codes and set the operation mode selector to TV/AV to change the control area.
Note
Depending on the external A/V component you are using, you may not be able to operate the component with the remote control, even if a remote control code is set. In this case, operate the component using the supplied remote control.
Setting remote control codes
You can control other components by setting the appropriate remote control codes. Codes can be set up for each input area (TV, STB, DVD, VCR and AUX).
For a complete list of available remote control codes, refer to “LIST OF REMOTE CONTROL CODES” at the end of this manual.
STB | VCR | DVD |
| AUX |
INPUT1 | TV |
| MACRO | |
INPUT2 | ||||
TV |
|
|
|
|
| AUTO | INPUTMODE | SLEEP | |
VOL MODE SETUP | ||||
5BEAM | ST+3BEAM | 3BEAM | ||
1 |
| 2 |
| 3 |
STEREO | MY BEAM SURROUND | |||
4 |
| 5 |
| 6 |
MUSIC | MOVIE | SPORTS | ||
7 |
| 8 |
| 9 |
OFF |
|
|
|
|
0 | +10 |
|
| |
CH LEVEL |
|
|
| MENU |
TV/AV
ENTER
YSP
TESTRETURN
VOLUME | CH | TV VOL |
MUTE | TV INPUT TV MUTE |
2Press the numeric buttons to enter the remote control code while holding down
CODE SET.
Setting example: YAMAHA DVD input area
| SURROUND |
| 6 |
TV MUTE |
|
While holding | SPORTS |
down, press | 9 |
CODE SET |
|
| SPORTS |
| 9 |
3Refer to “Controlling other components” on page 78 to operate the external component using the remote control.
If the external component functions correctly, the remote control code setup was successful.
If the external component does not function correctly, the remote control code may be incorrect. Confirm that the remote control code is correct (see “LIST OF REMOTE CONTROL CODES” at the end of this manual) and start over from step 1.
Note
If the manufacturer of your component has more than one code, try each of them until you find the correct one.
CODE SET
1Press and hold CODE SET on the remote control and then press one of the input selector buttons to select the input source you want to set a remote control code for.
The transmission indicator flashes twice and then remains lit.
Proceed to step 2 while holding down CODE SET.
TV MUTE | STB | VCR | DVD | AUX |
|
|
|
| |
While holding |
|
|
|
|
down, press | TV |
|
|
|
CODE SET |
|
|
| |
|
|
|
|
If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries and reset the remote control codes.
When changing the batteries, be careful not to press any of the buttons on the remote control. Doing so will clear the contents of the memory.
English