GE D780 manual Case of Equipment Malfunction, Rights of the Telephone Company, FCC Notice

Page 7

In Case of Equipment Malfunction

Should any malfunction occur which cannot be corrected by the procedures described in this Fax Guide, disconnect the equipment from the telephone line and unplug the power cord. The telephone line should not be reconnected or the power cord plugged in until the problem is completely resolved. Users should contact Canon Authorized Service Facilities for servicing of equipment. Information regarding Authorized Service Facility locations can be obtained by calling the Canon USA Consumer Information Center. (1-800-828-4040)

Rights of the Telephone Company

Should the equipment cause harm to the telephone network, the telephone company may temporarily disconnect service. The telephone company also retains the right to make changes in facilities and services which may affect the operation of this equipment. When such changes are necessary, the telephone company is required to give adequate prior notice to the user.

FCC Notice

Facsimile Transceiver, Model F188300

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept interference received, including interference that may cause undesired operation.

• This equipment has been tested and found to comply with the limits for a class B digital device, pursuant NOTE to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.

Do not make any changes or modifications to the equipment unless otherwise specified in the Fax Guide. If such changes or modifications should be made, you could be required to stop operation of the equipment.

Canon U.S.A. Inc.

One Canon Plaza, Lake Success, NY 11042, U.S.A.

TEL No. (516) 328-5000

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business or other entity, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual.

To automatically enter this information into your machine, follow the instructions in Chapter 2 of this guide.

vi

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Fax Guide Copyright Using Your DocumentationTrademarks Page Contents Appendix Specifications Special FeaturesTroubleshooting Setting the Additional FunctionsUsers in the U.S.A Pre-Installation Requirements for Canon Facsimile EquipmentConnection of the Equipment Rights of the Telephone Company Case of Equipment MalfunctionFCC Notice Order Information Users in CanadaFor Canadian Users TX/RX no Type Conventions Used in This GuidePage Customer Support IntroductionOperation Panel Fax Monitor Key Standby Display Connecting the Telephone Line and an External DeviceMaking Connections Drpd External Device ConnectionsRegistering Information Guidelines for Entering Numbers, Letters and SymbolsMethods of Registering Information in the Machine Letter you want Correcting a MistakeRegistering Required Sender Information What is Sender Information?Registering Your Fax/Telephone Number and Name Entering the Date and TimePress Additional Functions Use 4 -or e + to select 2.UNIT Name Lists Use 4 -or e + to select 7.PRINTPress Set three times Setting the Telephone Line TypeUse 4 -or e + to select 2.TEL Page Speed Dialing What is Speed Dialing?Use 4 -or e + to select a one-touch speed dialing key 01 to One-Touch Speed DialingRegistering Numbers for One-Touch Speed Dialing Use 4 -or e + to select 4.ADDTo Change a One-Touch Speed Dialing Entry Changing/Deleting a One-Touch Speed Dialing EntryTo Delete a One-Touch Speed Dialing Entry Use 4 -or e + to select a coded speed dialing code 00 to Coded Speed DialingRegistering Numbers for Coded Speed Dialing Use 4 -or e + to select 2.CODEDTo Change a Coded Speed Dialing Entry Changing/Deleting a Coded Speed Dialing EntryTo Delete a Coded Speed Dialing Entry To register a group under a one-touch speed dialing key Group DialingCreating Groups Use 4 -or e + to select 3.GROUP DialIf you want to delete one of these numbers from the group Additional Functions then repeat the procedure from stepTo enter a destination registered for coded speed dialing To continue registering other groups, pressUse 4 -or e + to select the list you want to print Speed Dialing ListsPrinting Speed Dialing Lists Use 4 -or e + to select 2.SPEEDTouch Detail Press Canceling the Print Out ListUse 4 -or e + to select 3.CANCEL Press Set Use 4 -or e + to select 7.PRINTUse 4 -or e + to select 2.TX Type Registering a Password and SubaddressUse 4 -or e + to select Use 4 -or e + to select onEnter a subaddress Enter a passwordPage Sending Faxes Adjusting the Quality of Your FaxesSetting the Scanning Resolution Press FAX Resolution to select Press SetRegular Dialing Dialing Methods5 7 9 5 1 1 1 Coded Speed Dialing One-Touch Speed DialingPress 4 -or e + to display the other names Group DialingDirectory Dialing Press DirectoryDial the other party’s fax number Stop/Reset then pressSending Methods Memory SendingPress Start to begin scanning Press FAX to set to Fax ModePress Function Press Book Sending Press Set Dial the other party’s fax numberPress Function Press Fax Monitor Canceling SendingCanceling memory sending Press Stop/ResetManual Redialing Redialing When the Line is BusyCanceling Manual Redialing Canceling Automatic RedialingCoded speed dialing Sequential BroadcastingSending a Document to More Than One Destination One-touch speed dialingPress Start Press Function Press Delayed Transmission Delayed SendingFunction and then Book Sending , Confirming Transmission Status Confirming Transmission Status and Sending ReservationConfirming Sending Reservation Press Memory Reference Documents Stored in MemoryPrinting a List of Documents in Memory Press FunctionEnter the fax number Press Set Resending a Document in MemoryPress Function Press Memory Reference Use 4 -or e + to select 4.RESENDUse 4 -or e + to select 3.PRINT Printing a Document in MemoryUse 4 -or e + to select 5.DELETE Deleting a Document from MemoryPress 4 -to delete the document Receiving Faxes Receive Mode Main Use Operation RequirementsDifferent Ways to Receive a Fax Press Receive Mode until the mode you Press Set Want appears What Happens When FaxTel Mode is Selected Setting the Options for FaxTel ModeUse 4 -or e + to select 2.FAX/TEL OPT.SET Use 4 -or e + to select 4.RXUse 4 -or e + to select Receive or Types of Ring Patterns If you hear a person’s voice Receiving Faxes ManuallyIf you hear a slow beep tone or silence Use 4 -or e + to select Polling RX Registering a Password and Subaddress for PollingPolling RX 1.PASSWORD Password Receiving While Performing Other Tasks Receiving Faxes in Memory When a Problem OccursCanceling Receiving Press 4 -to cancel receivingPage Special Dialing Special FeaturesDialing an Overseas Number With Pauses Switching Temporarily to Tone Dialing Description Reports and ListsSummary of Reports and Lists Report or ListPress Report Activity ReportSlerexe Company Limited TX Transmission ReportMulti TX/RX Transaction Report RX Reception ReportCause TroubleshootingLCD Messages MessageFaxes sent from the machine are spotted or dirty Faxing ProblemsSending Problems You cannot send a faxCannot receive a fax automatically Receiving ProblemsCannot send using Error Correction Mode ECM Errors occur frequently while sendingPrint quality is poor Cannot receive using Error Correction Mode ECMErrors occur frequently while receiving Cannot receive a document manuallyTelephone disconnects while you are talking Telephone ProblemsIf a Power Cut Occurs You cannot dialIf You Cannot Solve the Problem Press 4 -or e + to select the menu you want to change Setting the Additional FunctionsUnderstanding the Additional Functions Press Additional Functions to display the menusName Descriptions Menu DescriptionsCopy Settings FAX Settings Print Error only Receive Double Ring RX to Memory ADD. Registration Timer Settings Telephone SpecificationsPage Index CancelingDocument Memory List Memory Clear Report RX Report Standard Memo Canon Italia S.p.A Canon Deutschland GmbH
Top Page Image Contents