Alternative configuration
MPEGscope Plus and MPEGscope Lite
This configuration applies only if your MPEGscope is housed in a Kayak XU PC (e.g., E6277B or E6277C). It enables you to have both the SMPTE 310M interface and another optional line interface (e.g., the ASI & Serial ECL (DHEI) interface) installed at the same time. The configuration requires repositioning all MPEGscope cards into the first four slots, and replaces Steps 2 and 3 on pages 6 to 8. Follow all other steps as usual.
1 Remove the cards from slots 2, 3 and 4, disconnecting cables as necessary.
3Attach the IAB ribbon cable to the MPEGscope main card then install the card into slot 3.
6Install the SMPTE 310M interface card into slot 4.
5Connect the IAB ribbon cable from the MPEGscope main card to the optional line interface (e.g., the ASI & Serial ECL (DHEI) interface).
2 Remove the blank faceplate | 4 Install the optional line |
and install the | interface (e.g., the ASI & |
Analyzer card into slot 1. | Serial ECL (DHEI) interface) |
| into slot 2. |
7Connect the ribbon cable from the MPEGscope main card to the
9