Agilent Technologies SMPTE 310M manual Connecting to the Smpte 310M interface, DVB-SPI Tx

Page 28

Connecting to the SMPTE 310M interface

Connecting to the SMPTE 310M interface

DVB–SPI interface on MPEGscope main board

DVB–SPI Tx

EXT CLK IN

DVB–SPI Rx

 

 

1Connect the SCSI 26-pin male connector labelled SPI Tx on the DVB–SPI Y–Adapter cable to the DVB-SPI Tx port on the MPEGscope main board.

4Connect the output line to your system under test to the OUT port on the SMPTE 310 interface.

SMPTE 310M interface

SMPTE310M

OUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To system under test...

2 Connect the SCSI

26-pin male connector labelled SPI Rx on the DVB– SPI Y–Adapter cable to the DVB-SPI Rx port on the MPEGscope main board

3 Connect the single SCSI

50-pin connector on the DVB-SPI Y-Adapter cable to the DVB-SPI IN/OUT port on the SMPTE 310M interface.

IN

E6292A

 

DVB–SPI IN/OUT

5Connect the input line from your system under test to the IN port on the SMPTE 310M interface.

20

Image 28
Contents Smpte 310M Interface Installation Guide Manual Name Copyright Warranty MPEGscope+61-3-8877-8633 Safety Symbols Indicates that antistatic precautions should be takenCertification Additional Information for Test and Measurement EquipmentSymboles de sécurité AvertissementCet instrument est conforme aux IiiPage Contents Contents-1Page Interface Installation Guide E6292-94000 Interface Printed Circuit Assembly E6292-66501Introduction IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Install the Real-time Remove the blank faceplateAnalyzer card into slot Into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Plastic guide for GuideSmpte 310M interface installed in slot Connecting to the Smpte 310M interface Connecting to the Smpte 310M interfaceDVB-SPI Tx To system under test Connect the ScsiConfiguring the software Configuring the softwarePage Select the Tx tab Configuring the software Select the Rx tabClose the dialog Between consecutive packets Smpte 310M interface specificationsCables on all interfaces Release Notes Release Notes