Agilent Technologies SMPTE 310M Configuring the software Select the Rx tab, Select the Tx tab

Page 31

Configuring the software

5 Select the Rx tab.

6Select receiver options.

7Select the Tx tab.

8Select transmitter options.

9 Close the dialog.

For information about receiver and transmitter options, press the Help button at the bottom of the dialog. You can also click on a field using the right mouse button.

23

Image 31
Contents Smpte 310M Interface Installation Guide Manual Name Copyright Warranty MPEGscope+61-3-8877-8633 Additional Information for Test and Measurement Equipment Safety SymbolsIndicates that antistatic precautions should be taken CertificationAvertissement Symboles de sécuritéIii Cet instrument est conforme auxPage Contents-1 ContentsPage Introduction Interface Installation Guide E6292-94000Interface Printed Circuit Assembly E6292-66501 IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Into slot Install the Real-timeRemove the blank faceplate Analyzer card into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Guide Plastic guide forSmpte 310M interface installed in slot To system under test Connect the Scsi Connecting to the Smpte 310M interfaceConnecting to the Smpte 310M interface DVB-SPI TxConfiguring the software Configuring the softwarePage Select the Tx tab Configuring the software Select the Rx tabClose the dialog Between consecutive packets Smpte 310M interface specificationsCables on all interfaces Release Notes Release Notes