Agilent Technologies SMPTE 310M manual Tabs

Page 22

MPEGscope Portable and Portable Lite

5Carefully lay MPEGscope Portable face down with the handle towards you.

screw

#1

screw

#4

screw

#2

screw

#5

screw

#3

screw

#6

6Remove the six back panel screws from the back and side, then lift off the back panel.

7Remove the two metal shield screws, then gently pull tabs from slots and remove the metal shield.

screw

#1

screw

#2

tabs

tabs

14

Image 22

Contents Smpte 310M Interface Installation Guide Manual Name Copyright Warranty MPEGscope+61-3-8877-8633 Certification Safety SymbolsIndicates that antistatic precautions should be taken Additional Information for Test and Measurement EquipmentSymboles de sécurité AvertissementCet instrument est conforme aux IiiPage Contents Contents-1Page Introduction Interface Installation Guide E6292-94000Interface Printed Circuit Assembly E6292-66501 IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Analyzer card into slot Install the Real-timeRemove the blank faceplate Into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Plastic guide for GuideSmpte 310M interface installed in slot DVB-SPI Tx Connecting to the Smpte 310M interfaceConnecting to the Smpte 310M interface To system under test Connect the ScsiConfiguring the software Configuring the softwarePage Select the Tx tab Configuring the software Select the Rx tabClose the dialog Between consecutive packets Smpte 310M interface specificationsCables on all interfaces Release Notes Release Notes