Agilent Technologies SMPTE 310M manual Remove optional interface

Page 23

MPEGscope Portable and Portable Lite

Step 2: Remove optional interface

Complete this step if your MPEGscope already has an optional interface installed and you want to replace it with the SMPTE 310M interface.

IMPORTANT:	1	Attach the antistatic wrist strap to your wrist and to the PC chassis as described in the

instructions on the envelope. Ensure that the copper foil end of this strap attaches to an electrical ground.

5If your optional line interface is connected to the MPEGscope main card with a cable, disconnect the other end of the cable from the MPEGscope main card and remove the cable.

3If your optional line interface is connected to the MPEGscope main card with a cable, disconnect the cable from the optional interface card.

4Remove the faceplate screw from slot 2 with the screwdriver provided, then remove the optional line interface.

2If your MPEGscope has a Real-time Analyzer, disconnect the ribbon cable connector from the Real-time Analyzer card. The cable runs from the MPEGscope main card to the Real-time Analyzer card.

15

Image 23

Contents Smpte 310M Interface Installation Guide +61-3-8877-8633 Copyright Warranty MPEGscopeManual Name Additional Information for Test and Measurement Equipment Safety SymbolsIndicates that antistatic precautions should be taken CertificationAvertissement Symboles de sécuritéIii Cet instrument est conforme auxPage Contents-1 ContentsPage Introduction Interface Installation Guide E6292-94000Interface Printed Circuit Assembly E6292-66501 IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Into slot Install the Real-timeRemove the blank faceplate Analyzer card into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Guide Plastic guide forSmpte 310M interface installed in slot To system under test Connect the Scsi Connecting to the Smpte 310M interfaceConnecting to the Smpte 310M interface DVB-SPI TxConfiguring the software Configuring the softwarePage Close the dialog Configuring the software Select the Rx tabSelect the Tx tab Cables on all interfaces Smpte 310M interface specificationsBetween consecutive packets Release Notes Release Notes