Westell Technologies 2400 manual Router Installation via USB

User Guide 4-Port Router (Model 2400)

Figure 2. Router Connection via 10/100 Base-T Ethernet

5.2 Router Installation via USB

!

NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install the Router via Ethernet connections.

The Router allows you to network your primary computer via Ethernet or USB installation. Westell recommends that you connect your Router using an Ethernet installation

1.Connect the power supply cord to the power connector marked 12V on the rear panel of the Router. Plug the other end of the power supply cord into a surge-protected AC wall socket.

2.Connect the DSL phone cable from the connectoron the rear panel of the Router marked to the DSL- equipped telephone line jack on the wall.

	WARNING: The connection to the Router’s DSL jack must come from a non-filtered connection to the
!	telephone jack on the wall. If you are using a microfilter, then be certain that the DSL phone cable is
	connected to the “DSL/HPN” non-filtered jack. You must use the phone cord that was provided with the
	Router kit.

3. Connect the USB cable from the USB connector		on the rear panel of the Router to the USB port on the
PC.
030-300331 Rev. A	9	October 2002