Westell Technologies 2400 manual 030-300331 Rev. a

User Guide	4-Port Router (Model 2400)
NOTE: The configuration	PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
specified by your Service	PPPoE = Point to Point Protocol over Ethernet
Provider will determine which	Bridge = Bridge Protocol
Protocols are available to you.	Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
	Mode). This is an ATM encapsulation of the IP protocol.
Bridge Broadcast	Factory Default = CHECKED
	When this setting is CHECKED, the Router will allow Broadcast IP packets
	to/from the WAN.
	When this setting is NOT CHECKED, the router will block Broadcast IP
	packets to/from the WAN.
	This setting is only valid if one of the Virtual Channels is configured for
	Bridge mode.
Bridge Multicast	Factory Default = CHECKED
	When this setting is CHECKED, the Router will allow Multicast IP packets
	to/from the WAN.
	When this setting is NOT CHECKED, the Router will block Multicast IP
	packets to/from the WAN.
	This setting is only valid if one of the Virtual Channels is configured for
	Bridge mode.
Spanning Tree Protocol	Factory Default = DISABLED
	Spanning Tree Protocol is a link management protocol that provides path
	redundancy while preventing undesirable loops in the network. For Ethernet
	network to function properly, only one active path can exist between two
	stations.
	When ENABLED, two bridges are used to interconnect the same two
	computer network segments. Spanning Tree Protocol will allow the bridges to
	exchange information so that only one of them will handle a given message
	that is being sent between two computers within the network.

The following settings will be displayed if you select edit from your VC Configuration menu on any of your existing VC (Virtual Connections) settings. If you change any of your existing VC settings, click on Set VC.

NOTE: Westell strongly recommends that you do not change any values in this section. If you experience any problems, please re-set your Router via the external hardware re-set button or via the procedure defined under the Maintenance menu.

030-300331 Rev. A 44 October 2002