User Guide

4-Port Router (Model 2400)

 

 

 

VC x PPPoE Settings

IP Address

Displays the IP network address that your modem is on.

Gateway

Displays the router IP Gateway address

DNS Primary

Provided by your Service Provider

DNS Secondary

Provided by your Service Provider

MRU Negotiation

Factory Default = DISABLED

 

If ENABLED, the Maximum Received Unit (MRU) would enforce MRU

 

negotiations. (NOTE: enable this option only at your Internet Service Provider’s

 

request.)

Tunneling

Factory Default = ENABLE

 

If ENABLED, this option allows PPP traffic to be bridged to the WAN. This feature

 

allows you to use a PPPoE shim on the host computer to connect to the Internet

 

Service Provider, by bypassing the Router’s capability to do this.

NOTE: The values for IP Address, Gateway, DNS Primary, and DNS Secondary are all “Override of the value obtained from the PPP connection,” They default to “0.0.0.0,” in which case the override is ignored. Westell recommends that you do not change these values unless you are instructed by the Internet Service Provider.

If you have made any changes to your VC settings, you need to save them. To save the new VC settings, click on OK when asked Set this PPPoE VC configuration? If you click on cancel, the new VC settings will not be saved.

DNS Configuration

The following settings will be displayed if you select DNS Configuration from the Configuration menu.

030-300331 Rev. A

46

October 2002

Page 48
Image 48
Westell Technologies 2400 manual DNS Configuration, VC x PPPoE Settings