030-300331 Rev. A 10 October 2002
4-Port Router (Model 2400)
User Guide
Congratulations! You have completed the USB hardware installation for your Router. You must now go to step 6
(INSTALL THE USB DRIVERS) to begin the USB drivers software installation.
Figure 3. Router Connection via USB
The 4-Port Router supports simultaneous use of 10/100 Base-T Ethernet and USB ports. Refer to the instructions
below for instructions on how to install your Router using both Ethernet and USB ports.
1. Connect the power supply cord to the power connector marked 12V on the rear panel of the Router. Plug
the other end of the power supply cord into a surge-protected AC wall socket.
2. Connect the DSL phone cable from the DSL jack on the rear panel of the Router to the DSL-equipped
telephone jack on the wall.
WARNING: The connection to the Router’s DSL jack must come from a non-filtered connection to the
telephone jack on the wall. If you are using a microfilter, then be certain that the DSL phone cable is
connected to the “DSL/HPN” non-filtered jack. You must use the phone cord that was provided with the
Router kit.
3. Connect the USB cable from the USB connector on the rear panel of the Router to the USB port on the
PC.
!