Agilent Technologies SMPTE 310M manual Install Smpte interface

Page 24

MPEGscope Portable and Portable Lite

Step 3: Install SMPTE interface

IMPORTANT: 1 Attach the antistatic wrist strap to your wrist and to the PC chassis as described in the instructions on the

envelope. Ensure that the copper foil end of this strap attaches to an electrical ground.

2Install the SMPTE 310M interface card into slot 2 and screw the faceplate to the PC chassis. (If this is the first interface installed into slot 2, you will have to remove the blank faceplate first.)

16

Image 24
Contents Smpte 310M Interface Installation Guide Copyright Warranty MPEGscope Manual Name+61-3-8877-8633 Safety Symbols Indicates that antistatic precautions should be takenCertification Additional Information for Test and Measurement EquipmentSymboles de sécurité AvertissementCet instrument est conforme aux IiiPage Contents Contents-1Page Interface Installation Guide E6292-94000 Interface Printed Circuit Assembly E6292-66501Introduction IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Install the Real-time Remove the blank faceplateAnalyzer card into slot Into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Plastic guide for GuideSmpte 310M interface installed in slot Connecting to the Smpte 310M interface Connecting to the Smpte 310M interfaceDVB-SPI Tx To system under test Connect the ScsiConfiguring the software Configuring the softwarePage Configuring the software Select the Rx tab Select the Tx tabClose the dialog Smpte 310M interface specifications Between consecutive packetsCables on all interfaces Release Notes Release Notes