Agilent Technologies SMPTE 310M manual Configuring the software

Page 29

Configuring the software

Configuring the software

Because the SMPTE 310M interface receives and transmits data via the MPEGscope SPI interface, you do not need special SMPTE 310 interface software. You can set receiver and transmitter options from the SPI interface application, as illustrated below.

1 Select the SPI interface.

For information about this dialog, press the Help button.

21

Image 29
Contents Smpte 310M Interface Installation Guide +61-3-8877-8633 Copyright Warranty MPEGscopeManual Name Indicates that antistatic precautions should be taken Safety SymbolsCertification Additional Information for Test and Measurement EquipmentAvertissement Symboles de sécuritéIii Cet instrument est conforme auxPage Contents-1 ContentsPage Interface Printed Circuit Assembly E6292-66501 Interface Installation Guide E6292-94000Introduction IntroductionLocation Number MPEGscope Plus and MPEGscope Lite MPEGscope Plus and MPEGscope LiteRemove the cover MPEGscope Plus and MPEGscope Lite Remove optional interface MPEGscope Plus and MPEGscope Lite Install Smpte interface Remove the blank faceplate Install the Real-timeAnalyzer card into slot Into slotReplace the cover Smpte 310M interface installed in slot MPEGscope Portable and Portable Lite MPEGscope Portable and Portable LiteRemove the cover Tabs Remove optional interface Install Smpte interface Page Guide Plastic guide forSmpte 310M interface installed in slot Connecting to the Smpte 310M interface Connecting to the Smpte 310M interfaceDVB-SPI Tx To system under test Connect the ScsiConfiguring the software Configuring the softwarePage Close the dialog Configuring the software Select the Rx tabSelect the Tx tab Cables on all interfaces Smpte 310M interface specificationsBetween consecutive packets Release Notes Release Notes