Provisioning | |
|
|
Configuring the System
The Config menu (Figure 6) allows you to make the following types of system configuration changes:
•Standard options (Figure 7 on page 18)
•ADC options (Figure 8 on page 18)
•BERT Generator (Figure 30 on page 56)
•Date and time (see “Setting Date and Time” on page 15)
•Master clear (see “Clearing the History, Alarm, and Event Log Screens” on page 24)
•Reset to factory default configuration (Figure 9 on page 23)
Monitor | Performance Event Log | Config | Inventory | Report Rlogon | Help | ||
|
|
| + |
| |||
| Standard Options |
|
| ||||
ADC Options |
|
| |||||
| BERT Generator |
| |||||
Date and Time |
| ||||||
| Master Clear |
|
| ||||
| Set Factory Defaults |
| |||||
|
| + |
| ||||
ID: | 02/01/2002 12:30:01 | System: OK___ |
Figure 6. Config Menu
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 18 show the Standard and ADC configuration options. Standard options are supported by HDSL4 units when connected to units from other vendors. ADC options are an extended set of options available only when using ADC units exclusively. For a description of each option and a list of possible option settings, refer to Table 5 on page 19 and Table 6 on page 20. To make changes to these options:
1Press C to select the Config menu.
2Use the ↑ and ↓ arrow keys to select Standard Options or ADC Options, then press ENTER .
3Use the arrow keys to select an option.
4Press the SPACEBAR to cycle through the available settings for that option.
5Press ENTER to activate your choice.
The message May need to change MUX option after changing this option appears when changing the DS1 Line Coding (DS1) or
September 12, 2003 | 17 |