Preparing and using the remote control
Loading dry-cell batteries into the remote control
1Remove the battery cover.
2Insert the
Be sure to align the plus and minus ends of the batteries properly.
Operating the remote
control
Point toward the projector’s infrared remote sensor, and press any button on the remote control.
• Operating the projector from the front
Approx.15°
Appro x.5m
Preparations
Two batteries (R03, SIZE AAA) are used.
3Replace the battery cover.
When operating the remote control from behind the projector, the infrared signal is reflected on the projecting surface and may travel a shorter distance to reach the projector depending on the shape and material of the projecting surface.
Dry-cell batteries
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones. (2 batteries (R03, SIZE AAA))
•Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries are swallowed, seek medical assistance immediately.
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not allow it to get wet or place it on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
19