Tuning the TV Stations and Setting the Time and Date Automatically
Plug your DVD/VCR into the mains sup- ply and it will start to automatically tune itself in and set the correct date and time. After setting itself up, you must set the TV to the video channel.
Notes:
•The DVD/VCR automatically corrects the clock setting every hour and automatically adjusts the clock setting for Daylight Saving Time.
•Your DVD/VCR will tune the TV
stations as follows. |
|
CH 1 | BBC 1 |
CH 2 | BBC 2 |
CH 3 | ITV |
CH 4 | Channel 4 |
CH 5 | Channel 5 |
CH 6 | Satellite |
CH 7 | etc. |
For VIDEO Plus+ recording to work correctly, this order should not be changed.
•If you want to change the RF output channel or switch to "OFF", press and
hold the DVD/VCR 
on the front of your DVD/VCR in the Standby mode until the current RF output channel appears. Press PR on your DVD/VCR to select the RF channel you desire.
•Skipped channels still may be selected directly through the 1 to 0 keys.
•To cancel skipping select the skipped channel using the 1 to 0 keys, then press CANCEL. The channel No. does not blink any longer, and the channel No. now may be selected again using PR.
Preparation
• Make sure that your DVD/VCR is connected properly to the TV.
• If a satellite receiver is connected with the coaxial lead, make sure it’s switched ON and set to SKY ONE.
• Turn on the TV and select the channel you wish to allocate for video use.
1 Plug your DVD/VCR's plug into the mains supply. "Auto" will start to flash in the display. Your DVD/VCR will auto- matically tune itself in and set the correct
time and date (This may take approx. 4 minutes).
2 Press and hold the | button on the front of your DVD/ | ||
VCR in the Standby mode until "rF" | |||
and RF output channel "52" will |
|
| |
appear in the display. |
|
|
|
|
|
| |
3 If you have used a 21PIN scart lead you now, simply se- lect the AV channel on your TV and go to step 5. Tune the TV in the same way as tuning in a TV broadcast station until the word "TEST" flashes on the TV screen. Refer to the TV operating instructions for tuning.
Now the output from the DVD/VCR is tuned to this channel. Whenever you want to play back a tape, select this channel.
4 If there is interference in the picture (wavy lines, picture roll, etc.), press PR on your DVD/VCR to select any RF channel between 23 and 69, retuning your TV until the word "TEST" flashes on the TV screen.
If you connected a satellite receiver as explained on page 11, you must switch off the DVD/VCR’s transmitter. Press the VCR’s PR repeatedly until OFF appears in the display window (OFF will appear
after 69 or before 23).
5 Press the 
button to turn OFF the DVD/VCR. Now the TV is tuned to your DVD/VCR.
To skip a channel position
Unwanted channels can be
skipped so that they cannotCH 29 be called up by pressing PR.
Select the channel to be skipped,
...e.g. channel 29. Select channel 29, then press
CANCEL.
This channel’s number will be flashing. That way you can cancel further channels one after the other.
13