JVC HR-XV1EK manual Instant Timer Recording ITR, To Extend the Recording Time, To stop the ITR

Instant Timer Recording (ITR)

The instant timer recording feature provides a simple and convenient way to make a timed recording.

Note:

•If you wish to watch the DVD playback during the ITR, press DVD to change to DVD mode and perform the DVD play- back (see page 38).

•If the tape supply has not sufficed for ITR recording, the clock symbol ( ) will blink at the tape-end and then VCR

mode will change to DVD mode.

In this case, press • to cancel the blink or press EJECT to remove the cas- sette tape.

Preparation:

•Turn ON the TV and select the VCR channel on TV.

•Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then press VCR to select the VCR mode. (The VCR indicator will light)

1 Load a blank cassette tape with the erase prevention tab intact. (The DVD/VCR will automatically turn on.)

VCR

2 Select the program (e.g.29) you want to record with PR +/– or

number keys.
1~9 : e.g. 5 = press “5”
	VCR
10~80 : e.g. 29 = press “2” and “9”.

3 If a recording in Long Play mode is intended, press	(TAPE
SPEED) to display "LP". (see note on page 28)
4 Press 2 on the VCR or while holding 2, press	on

the Remote to begin recording. Press 2 on the VCR again to stop recording after 30 minutes. Each additional press of 2 will increase recording time as shown in the chart below, up to a maximum of 5 hours. The ITR and

recording time will appear on the						ITR 0:30
						CH 29
screen for about 4 seconds. And,				STEREO
REC will keep blinking in the display.
	VCR
	REC
				INDEX
“REC” will keep blinking
	in the display.
Tape speed: SP
Recording			0:30	1:00	1:30
5:00			4:00	3:00	2:00
	Tape speed: LP					2:00
Recording			0:30	1:00	1:30
10:00		.......		5:00	4:00	3:00

To Extend the Recording Time

While holding 2, press .

repeatedly until the desired timeITR 1 : 30 CH 29

appears on the display.

To stop the ITR

Press 3.

26