JVC HR-XV1EK manual Video Index Search System, Recording several Index Marks

Video Index Search System

Whenever a recording is begun an invisible index mark is recorded on the tape.These index marks are all identical, and each mark means: "Here starts a new recording". Every DVD/VCR equipped with the Video Index Search System (VISS) can locate these marks at the beginning of any recording.

Notes:

•When you record an INDEX mark at the very beginning of the tape, the mark may not be found.

•During INDEX search, the tape may stop and begin to play at a slightly different location.

•INDEX may not function properly with old or worn out video tapes.

•INDEX marks may not be found if it is extremely close to the point where the search began.

•In recording, if you stop recording tem- porarily, the INDEX mark is not re- corded on the tape.

Example: Indexing of TV commercials.

1 Start playback and wait until the end of the TV commercial is reached, then press 3.

2 While holding 2, press once. When the "INDEX" on-screen indication goes off, 3 may be pressed. This short recording process will be sufficient to set an index mark.

This will result in about 10 seconds of the TV commercials to be overwritten by another recording. Due to the system the end of this recording will be followed by a recording gap (noise signal) of approx. 5 seconds.

Recording several Index Marks

Due to the system only one index mark will be recorded at the beginning of a recording. If you intend to set several index marks during a single recording, follow the procedure below:

1 At the point of the recording where an index mark is to be set press 4. The unit will switch to the recording pause mode.

	VCR
	REC		CH2
		INDEX
	REC
2 Press PR repeatedly to switch back
to the original TV program. Press
4 to resume recording.
	VCR			+3
Index Search
Press INDEX + or – during stop or play
mode.
For Succeeding programs:
Press INDEX +.
For Preceding programs:
Press INDEX –.
(Additional press increases the INDEX
NO. up to 9.)
		7 or 6 is displayed
When the INDEX + or – is pressed, the
unit starts searching the INDEX NO.		INDEX NO. (up to 9)
selected and finds the portion, then

playback starts automatically.

To stop the Index Search, press 3.

23