Gefen EXT-HDMI1.3-CAT6-4X user manual Receiver Panel Descriptions, Control Buttons

Page 10

RECEIVER PANEL DESCRIPTIONS

1Control Buttons

When connected to any 4x4 Matrix for HDMI, these remote buttons on the Receiver unit can switch between the 4 Hi-Def inputs connected to the 4x4 Matrix for HDMI.

2IR Sensor

Control the Receiver unit by pointing the IR Remote Control to the IR Sensor.

3EQ Trimpot

Used to equalize the signal to compensate for distance and skew variations found in various brands of CAT-6 cable.

4Input Indicators (HDMI In 1 - HDMI In 4)

An LED will Displays the current input of the 4x4 Matrix.

5Power Indicator

This LED will turn bright red once the power supply has been properly connected.

6IR Extender Port

Used to extend the IR Sensor range of the Receiver unit.

7CAT6 In Connector

Connect the CAT-6 cable from the Sender unit to the RJ-45 connector.

8HDMI Out

Connect the HDMI cable from the HDTV display to the HDMI Out.

9RS-232 Input

Connects a controlling device to this port.

105V DC Locking Power Connector

Connects the included 5V DC Locking Power Supply to this receptacle.

7

Image 10

Contents 4x CAT6 Extender For Hdmi Technical Support Hours Asking for AssistanceTechnical Support Write ToContents Gefen 4x CAT6 Extender for Hdmi IntroductionGefen How It WorksOperation Notes Features FeaturesSupported Hdmi 1.3 Features Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi Default settings for DIP switches DIP Switch ConfigurationDIP Switch Location Matrix Mode / Stand-alone Mode Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Serial Control Interface RS-232 SettingsBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandCommand RS-232 Serial CommandsFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA