Gefen EXT-HDMI1.3-CAT6-4X user manual Connecting and Operating the 4X CAT6 Extender for Hdmi

Page 20

CONNECTING AND OPERATING THE 4X CAT6 EXTENDER FOR HDMI

How to Equalize the 4x CAT6 Extender for HDMI

(Matrix Mode / Stand-alone Mode)

The 4x CAT6 Extender for HDMI Receiver unit has an equalization trimpot to

compensate for variances that can be found in different CAT-6a cable brands. If there is no output video or if output video contains artifacts and/or video noise, use the steps below to adjust the EQ trimpot.

EQ trimpot

1.Insert a small ﬂat-head screwdriver into the trimpot on the front panel of the Receiver unit.

2.The EQ trimpot can be set to one of eight different positions. Turn the trimpot clockwise until it clicks into the next position. Continue adjusting the trimpot until the signal shows best results.

17

Image 20

Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelBinary Table RS-232 SettingsRS-232 Serial Control Interface Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandFunctions Syntax RS-232 Serial CommandsCommand Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA