DIP SWITCH CONFIGURATION
DIP Switches
(Matrix Mode /
DIP 1 - EDID Management
•OFF - Local EDID
When Local EDID mode is used, the EDID will be assembled by copying all video and audio features of the connected device. Deep Color support will be manually controlled: If Deep Color is supported by the display(s), DIP 2 should be set to the ON position (see DIP 2 - Deep Color, below). By default, the unit is shipped with DIP 1 in the OFF position.
•ON - Pass-through EDID
Allows all video and audio features of the connected devices to be passed to the source device without control over Deep Color.
DIP 2 - Deep Color
•OFF - Disables Deep Color support
Disables Deep Color in the EDID. Deep Color management is only available when Local EDID is being used (DIP 1 = OFF).
•ON - Enables Deep Color support
Enables Deep Color support. In
DIP 3 / DIP 4 - IR Remote Channel
The IR channel assigned to the IR Remote Control must match the IR channel assigned to the 4x CAT6 Extender for HDMI Receiver unit. The factory setting (default) for DIP 3 and DIP 4 are in the OFF position.
|
|
|
|
|
|
|
|
|
| DIP 3 |
|
| DIP 4 |
| IR Channel | ||
| OFF |
| OFF |
|
|
| ||
|
| 1 |
| |||||
| ON |
| OFF | 2 |
| |||
| OFF |
| ON | 3 |
| |||
|
|
|
|
|
|
|
|
|
| ON |
| ON | 4 |
| |||
19