Gefen EXT-HDMI1.3-CAT6-4X RMT-4-IR Remote Installation, Installing the RMT-4-IR Battery

Page 12

RMT-4-IR REMOTE INSTALLATION

Installing the RMT-4-IR Battery

To use the RMT-4-IR Remote, remove the battery cover on the back of the

remote to reveal the battery compartment. Insert the included battery into the open battery slot. The positive (+) side should be facing up. Ensure that both DIP switches are set to the OFF position. Replace the battery cover and the IR Remote is ready for action.

The IR Remote ships with 2 batteries. One battery is required for operation and the other battery is a spare.

Battery Slot

I/R Code DIP Switches

9

Image 12

Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Settings RS-232 Serial Control InterfaceBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandRS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA