Gefen EXT-HDMI1.3-CAT6-4X user manual #RMTIRADD Function, #LOCKPOWER Function

Page 27

RS-232 SERIAL COMMANDS

General Functions

Simpliﬁed syntax was used for command implementation for faster operation with the device: # character – isn’t needed, the command name is reduced to 1 letter. The commands are not case-sensitive.


	Function			Description
#RMTIRADD				Routing command
#LOCKPOWER				Routes a single input to all outputs

#RMTIRADD Function

The #RMTIRADD function set the remote IR channel.

Syntax:

#RMTIRADD param1

Parameters:
param1	IR channel			[0 - 3]


		Value			Meaning
	0			IR channel 1
	1			IR channel 2
	2			IR channel 3
	3			IR channel 4

#LOCKPOWER Function

The #LOCKPOWER enables/disables the power lock state. Enabling this feature will store the 5V status for each input prior to shutting the unit down.

Syntax:

#LOCKPOWER param1

Parameters:
param1	State			[0 - 1]


		Value			Meaning

	0			Disable Power Lock
	1			Enable Power Lock

24

Image 27

Contents 4x CAT6 Extender For Hdmi Write To Asking for AssistanceTechnical Support Technical Support HoursContents How It Works IntroductionGefen Gefen 4x CAT6 Extender for HdmiOperation Notes Package Includes FeaturesSupported Hdmi 1.3 Features FeaturesSender Panel Layout CAT6 Output Jack Sender Panel DescriptionsReceiver Panel Layout Control Buttons Receiver Panel DescriptionsRMT-4-IR Remote Optional IR Remote DescriptionInstalling the RMT-4-IR Battery RMT-4-IR Remote InstallationSetting the IR Remote Channel on the RMT-4-IR RMT-4-IR Remote ConfigurationHow to Connect the 4x CAT6 Extender for Hdmi Matrix Mode Connecting the 4X CAT6 Extender for HdmiExample 1 Routing Input source 3 to Output display Connecting and Operating 4X CAT6 Extender for HdmiConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi Receiver Unit bottom DIP Switch ConfigurationDIP Switch Location Matrix Mode / Stand-alone Mode Default settings for DIP switchesDIP 3 / DIP 4 IR Remote Channel DIP 2 Deep ColorRS-232 Settings RS-232 Serial Control InterfaceBinary Table Use the RS-232 controller to send the following command Routing Sources using RS-232 Receiver Unit Matrix ModeRS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #RMTIRADD Function #LOCKPOWER FunctionView Matrix Status IP ControlIP Configuration Backup / Restore Power Management Pin Color Network Cable Wiring DiagramFirmware Update Procedure Firmware UpdateFirmware Update Specifications Product Registration WarrantyLicensing Page Rev C3 Nordhoff St., Chatsworth CA