Gefen EXT-HDMI1.3-CAT6-4X user manual DIP Switch Configuration, Receiver Unit bottom

Page 21

DIP SWITCH CONFIGURATION

DIP Switch Location

(Matrix Mode / Stand-alone Mode)

On the bottom of each Receiver unit, there are four (4) DIP switches. Each DIP switch performs a different function.

Before modifying DIP switch settings, disconnect the power from the Receiver unit. After the DIP switches have been conﬁgured, reconnect the power.

Receiver Unit (bottom)

DIP Switch

Bank

NOTE: By default, DIP 1 is set to the ON position

Default settings for DIP switches

DIP Switch	Position
1	OFF

2OFF

3OFF

4OFF

18

Image 21

Contents 4x CAT6 Extender For Hdmi Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Supported Hdmi 1.3 Features FeaturesFeatures Package IncludesSender Panel Layout CAT6 Output Jack Sender Panel DescriptionsReceiver Panel Layout Control Buttons Receiver Panel DescriptionsRMT-4-IR Remote Optional IR Remote DescriptionInstalling the RMT-4-IR Battery RMT-4-IR Remote InstallationSetting the IR Remote Channel on the RMT-4-IR RMT-4-IR Remote ConfigurationHow to Connect the 4x CAT6 Extender for Hdmi Matrix Mode Connecting the 4X CAT6 Extender for HdmiExample 1 Routing Input source 3 to Output display Connecting and Operating 4X CAT6 Extender for HdmiConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Location Matrix Mode / Stand-alone Mode DIP Switch ConfigurationDefault settings for DIP switches Receiver Unit bottomDIP 3 / DIP 4 IR Remote Channel DIP 2 Deep ColorRS-232 Settings RS-232 Serial Control InterfaceBinary Table Use the RS-232 controller to send the following command Routing Sources using RS-232 Receiver Unit Matrix ModeRS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #RMTIRADD Function #LOCKPOWER FunctionView Matrix Status IP ControlIP Configuration Backup / Restore Power Management Pin Color Network Cable Wiring DiagramFirmware Update Procedure Firmware UpdateFirmware Update Specifications Product Registration WarrantyLicensing Page Rev C3 Nordhoff St., Chatsworth CA