Gefen EXT-HDMI1.3-CAT6-4X user manual IP Control, View Matrix Status

Page 28

IP CONTROL

The Gefen 4x CAT6 Extender for HDMI supports IP-based control using an

integrated Web interface. To access this feature, an IP address, subnet, gateway, and port number need to be set on the 4x CAT6 Extender for HDMI ( Default IP: 192.168.0.70 Subnet: 255.255.255.0 Gateway: 192.168.0.1 Port: 80). Consult the network administrator to obtain the proper IP address and settings for this product to properly communicate on the network.

The IP control setting can be conﬁgured via the RS-232 control interface. Once this has been accomplished, access to the Web Interface is possible.

Simply type the IP address that was assigned to the product in a web browser to access the Web Interface. It should look like the image below.

VIEW MATRIX STATUS

The VIEW MATRIX STATUS page will display the current status and can also be used to create routes.

To create a new route, follow the steps below:

1.Select which outputs will display the source by clicking on each check box.

2.Select the radio button of the input that will be routed to each output.

3. Click the Switch button to update the new routing conﬁguration.

This page will automatically refresh every minute. However, at anytime the Refresh button can be pressed to refresh the status of the Matrix.

25

Image 28

Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Serial Control Interface RS-232 SettingsBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandCommand RS-232 Serial CommandsFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA