Gefen EXT-HDMI1.3-CAT6-4X user manual Connecting and Operating the 4X CAT6 Extender for Hdmi

Page 16

CONNECTING AND OPERATING THE 4X CAT6 EXTENDER FOR HDMI

How to Connect the 4x CAT6 Extender for HDMI with RS-232 control to

the 4x4 Matrix for HDMI and to the controlled device

1.Follow steps 1 - 6 on How to Connect the 4x CAT6 Extender for HDMI (see page 11).

2.Connect an RS-232 cable from the RS-232 serial port on the controlling device to the RS-232 In port on the rear of the 4x CAT6 Extender for HDMI Sender unit.

3. Connect another RS-232 serial cable from the RS-232 Out port on the rear of the 4x CAT Extender Sender unit to the RS-232 port on the rear of the 4x4 Matrix.

NOTE: Please refer to page 20 for details on configuring RS-232 control.

Example 1: Routing Input (source) 3 to Output (display) 1 using the 4x4 Matrix.

Make sure a Receiver unit is connected to CAT6 Out 1 on the Sender unit. Use the controlling device to send the following command:

r 1 3

The LED for In 3 will turn bright blue and the source from the 4x4 Matrix (In 3) will be displayed on the HDTV display connected to this Receiver unit. See page 22 for details on routing using RS-232.

13

Image 16
Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Serial Control Interface RS-232 SettingsBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandCommand RS-232 Serial CommandsFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA