Gefen EXT-HDMI1.3-CAT6-4X user manual Warranty, Product Registration

Page 36

WARRANTY

Gefen warrants the equipment it manufactures to be free from defects in material and workmanship.

If equipment fails because of such defects and Gefen is notified within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifications. Equipment that fails under conditions other than those covered will be repaired at the current price of parts and labor in effect at the time of repair. Such repairs are warranted for ninety (90) days from the day of reshipment to the Buyer.

This warranty is in lieu of all other warranties expressed or implied, including without limitation, any implied warranty or merchantability or fitness for any particular purpose, all of which are expressly disclaimed.

1.Proof of sale may be required in order to claim warranty.

2.Customers outside the US are responsible for shipping charges to and from Gefen.

3. Copper cables are limited to a 30 day warranty and cables must be in their original condition.

The information in this manual has been carefully checked and is believed to be accurate. However, Gefen assumes no responsibility for any inaccuracies that may be contained in this manual. In no event will Gefen be liable for direct, indirect, special, incidental, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. The technical information contained herein regarding the features and specifications is subject to change without notice.

For the latest warranty coverage information, refer to the Warranty and Return Policy under the Support section of the Gefen Web site at www.gefen.com.

PRODUCT REGISTRATION

Please register your product online by visiting the Register Product page

under the Support section of the Gefen Web site.

33

Image 36
Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Settings RS-232 Serial Control InterfaceBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandRS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA