Gefen EXT-HDMI1.3-CAT6-4X user manual RMT-4-IR Remote Configuration

RMT-4-IR REMOTE CONFIGURATION

Setting the IR Remote Channel on the RMT-4-IR

In the event that IR commands from other remote controls conflict with the

supplied RMT-4-IR Remote, changing the remote IR channel will fix this issue. The RMT-4-IR Remote has a bank of DIP switches for setting the Remote IR channel.

The DIP Switch bank on the RMT-4-IR is located underneath the battery cover.

Remote Channel 1:		Remote Channel 2:
Default
1	2	1	2
Remote Channel 3:		Remote Channel 4:
1	2	1	2

Left: Picture of the opened rear battery

compartment of the RMT-4-IR remote showing the exposed DIP Switch bank between the battery chambers.

The IR channel selected on the RMT-4-IR Remote must match the IR channel assigned to the 4x CAT6 Extender for HDMI. For example, if you set both DIP switches on the remote to the down position (IR channel 1), you must set the 4x CAT6 Extender for HDMI to use IR channel 1.

Please refer to page 19 on how to change the IR channel on the 4x CAT6 Extender for HDMI.

10