Gefen EXT-HDMI1.3-CAT6-4X user manual Connecting and Operating the 4X CAT6 Extender for Hdmi

Page 17

CONNECTING AND OPERATING THE 4X CAT6 EXTENDER FOR HDMI

How to Connect the 4x CAT6 Extender for HDMI

(Stand-alone Mode)

The 4x CAT6 Extender for HDMI is dependent upon an external 4x4 Matrix to manage all the zone switching. When used as a stand-alone, without the 4x4 Matrix attached, the product functions as a one-to-one extender for each HDMI unit. Four parallel extenders are used.

1.Connect an HDMI cable from the source device to HDMI In 1 on the back of the Sender unit.

2.Connect the Display to the 4x CAT6 Extender Receiver unit with a user- supplied HDMI cable.

3. Using a single CAT-6 cable, connect CAT6 Out 1 on the Sender unit to the CAT6 In on the Receiver unit.

4.If additional Receiver units will be used, complete these connections at this time, as described above.

5. Connect the 5V DC locking power supplies to each Receiver unit. Do not overtighten the locking connectors. Plug the power cord into an available wall outlet.

6. Connect the 24V DC power supply to the 4x CAT6 Extender for HDMI and plug the power cord into an available wall outlet.

14

Image 17

Contents 4x CAT6 Extender For Hdmi Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Supported Hdmi 1.3 Features FeaturesFeatures Package IncludesSender Panel Layout CAT6 Output Jack Sender Panel DescriptionsReceiver Panel Layout Control Buttons Receiver Panel DescriptionsRMT-4-IR Remote Optional IR Remote DescriptionInstalling the RMT-4-IR Battery RMT-4-IR Remote InstallationSetting the IR Remote Channel on the RMT-4-IR RMT-4-IR Remote ConfigurationHow to Connect the 4x CAT6 Extender for Hdmi Matrix Mode Connecting the 4X CAT6 Extender for HdmiExample 1 Routing Input source 3 to Output display Connecting and Operating 4X CAT6 Extender for HdmiConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Location Matrix Mode / Stand-alone Mode DIP Switch ConfigurationDefault settings for DIP switches Receiver Unit bottomDIP 3 / DIP 4 IR Remote Channel DIP 2 Deep ColorBinary Table RS-232 SettingsRS-232 Serial Control Interface Use the RS-232 controller to send the following command Routing Sources using RS-232 Receiver Unit Matrix ModeFunctions Syntax RS-232 Serial CommandsCommand Fiber Optic Extender Status F0 Command #RMTIRADD Function #LOCKPOWER FunctionView Matrix Status IP ControlIP Configuration Backup / Restore Power Management Pin Color Network Cable Wiring DiagramFirmware Update Procedure Firmware UpdateFirmware Update Specifications Product Registration WarrantyLicensing Page Rev C3 Nordhoff St., Chatsworth CA