Gefen EXT-HDMI1.3-CAT6-4X user manual Supported Hdmi 1.3 Features, Package Includes

Page 6

FEATURES

Supported HDMI 1.3 Features

•225 MHz (up to 12 bit YUV 444 @ 1080p)

•Deep Color

•Dolby TrueHD and DTS-HD Master Audio

•Lip-Sync

•CEC Pass-Through

Features

•Extends HDMI 1.3 at 1080p up to 200 feet (60 m)

•Extends DVI at 1920x1200 up to 200 feet (60 m) when using a passive HDMI-to-DVI adapter.

•3DTV Pass-Through

•Color Space Conversion

•IR Remote Control

•Built-in IR Extender and IR Back Channel

•RS-232 serial control

•IP Control (Sender unit feature)

•Audio and video are transmitted digitally for zero signal loss

•Supports multichannel digital audio formats including Dolby TrueHD and DTS-HD Master Audio

•Metal enclosure provides better RF shielding

•Compensation for cable skew

•Maintains settings on Power-On state

Package Includes

(1) 4x CAT6 Extender Sender Unit

(4) 4x CAT6 Extender Receiver Units

(4) 1 ft. HDMI Cables (M-M)

(1) RS-232 Serial Cable (M-F)

(1) 24V DC Power Supply

(4) 5V DC Locking Power Supplies

(1) Set of Rack Ears (Sender Unit Only)

(1) User Manual

3

Image 6

Contents 4x CAT6 Extender For Hdmi Technical Support Hours Asking for AssistanceTechnical Support Write ToContents Gefen 4x CAT6 Extender for Hdmi IntroductionGefen How It WorksOperation Notes Features FeaturesSupported Hdmi 1.3 Features Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi Default settings for DIP switches DIP Switch ConfigurationDIP Switch Location Matrix Mode / Stand-alone Mode Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelRS-232 Settings RS-232 Serial Control InterfaceBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandRS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA