Gefen EXT-HDMI1.3-CAT6-4X user manual Sender Panel Descriptions, CAT6 Output Jack

Page 8

SENDER PANEL DESCRIPTIONS

1Standby Button

Sets the 4x CAT6 Extender for HDMI into Standby Mode.

2IR Sensor

Receives signals from the IR Remote Control.

3Power Indicator

This LED will turn bright red once the locking power supply has been properly connected.

4IR Blaster (4)

Used to connect the IR Blaster to the Source device.

5CAT6 Output Jack (4)

Connects the Sender unit to the Receiver unit using CAT-6.

6RS-232 Serial Port (Input)

The 4x4 Matrix may be switched remotely using serial communications with any ofﬁce computer or a control automation device by connecting to this port. Please see page 20 for details.

7Locking HDMI Port (4)

Connect a HI-Def source to this HDMI port.

8IP Control

Connect to this port to control the 4x CAT6 Extender for HDMI using IP Control. See page 25 for more information.

9RS-232 Serial Port (Output)

Connects to the RS-232 control device. The 4x4 may be switched remotely using this port. See page 20 for details.

1024V DC Power Connector

Connects the included 24V DC power supply to this receptacle.

5

Image 8

Contents 4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It WorksOperation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package IncludesSender Panel Layout Sender Panel Descriptions CAT6 Output JackReceiver Panel Layout Receiver Panel Descriptions Control ButtonsIR Remote Description RMT-4-IR Remote OptionalRMT-4-IR Remote Installation Installing the RMT-4-IR BatteryRMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IRConnecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix ModeConnecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output displayConnecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottomDIP 2 Deep Color DIP 3 / DIP 4 IR Remote ChannelBinary Table RS-232 SettingsRS-232 Serial Control Interface Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following commandFunctions Syntax RS-232 Serial CommandsCommand Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD FunctionIP Control View Matrix StatusIP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin ColorFirmware Update Firmware Update ProcedureFirmware Update Specifications Warranty Product RegistrationLicensing Page Rev C3 Nordhoff St., Chatsworth CA